Chameleon Portable Antennas for HF

Chameleon Antennas is a manufacturer from the USA who has focussed on the design and manufacture of easy to use, lightweight yet robust portable shortwave and VHF antennas. The F-Loop is the first magnetic loop by Chameleon.

Chameleon F-Loop Nouveau

The design target for the CHA F-Loop was very low weight, flexible usage options, with a robust construction. The result is a QRP loop for portable operations which will endure use over many years to come. The CHA F-Loop is constructed from light-weight LMR-400 coaxial cable and an aluminium coupling loop (Faraday Loop). Another construction version, the CHA F-Loop 'Plus' uses a segmented aluminium ring instead of LMR-400, see below. The installation of the CHA F-Loop is usually done in 3 minutes.

The aluminium coupling loop is supported by a hardline coaxial feeder. This solid construction is helpful in maintaining a stable SWR even when turning or otherwise moving the antenna. The hardline feeder is connected to the top of the tuning box. The loop itself is constructed out of LMR-400 coaxial cable and covers all bands from 60 to 10m. With an optional cable extension a double loop can be built which covers even the 80m band. The Chameleon F-Loop is designed for a maximum transmit power of 10 W CW or 25 W SSB.

The tuning frequency range is from 5.3 to 29.7 MHz, with optional extension from 3.5 MHz. A switch on the tuning box selects the lower bands (40m and down), or the upper bands (30m and up). The tuning is done as with many magnetic loops in two steps: at first you tune for maximum noise on the desired frequency, then you transmit with low power and tune for lowest SWR.

By nature of their design magnetic loop antennas have a narrow bandwidth. This is beneficial, because this acts like a narrow pre selector filter in front of the receiver. The effect is fewer unwanted mixer products and overall improved reception quality. You can expect the usable bandwidths to range from 25 kHz on 7MHz to 150 kHz on 28MHz. This means that these bandwidths can be used without tuning the antenna, beyond these ranges the capacitor of the loop needs to be tuned again.

The diameter of the CHA F-Loop built with LMR-400 is 74cm. The antenna is suplied with the tuning box and a coaxial feed line (3.5m long, with RFI choke). Included in the shipment is also a solid carrying bag. The tuning box is installed on a solid base plate which can be installed on a photo tripod. A 3/8" thread is provided. The antenna supports itself in an upright position when put on a flat surface.

The CHA F-Loop is not weatherproof and should be operated only indoors are in a weather protected environment. The height above ground is not very critical, a height of 150cm is sufficient. As with all magnetic loop antennas the proximity of metal constructions can influence the tuning ability of the antenna.

The alternative CHA F-Loop 'Plus' is constructed with a solid aluminium 25 mm tube ring. The three segments are attached to each other by solid screws for a solid electrical connection. The larger diameter of the tube makes the F-Loop 'Plus' significantly more efficient. The diameter of the loop is 91.5cm. The 80m extension can not be used with this version of the antenna.

Ordine No.
11950 CHA F-Loop 525.00 € Ordina Nuovo
11950.80 80m Kit for CHA F-Loop Nuovo
11950.PLUS CHA F-Loop Plus 675.00 € Ordina Nuovo
Info sui costi di spedizione
CHA F-Loop
Chameleon F-Loop 'Plus'
Customer feedback

From: JH1DIS Sent: june 10, 2015 He says: Put the antenna at height of 60cm and more is better, Tuning is easy and smooth by matching mechanism with geared box. With SWR meter, can attain good SWR from 1.1 to 1.4. Assemble would be done within 5min. Totally 10min. to QRV, including to set up rig. At portable operation in mountains, he use lightweight photo tripod. Can put the antenna on a table too without additional support required.