Heil Microphones, Accessories and Spare Parts

The Heil Headsets and accessories are on an own page.


Heil PR-781 Desktop Microphone


PR-781

A new highend microphone which has been designed specifically for transceivers like the Icom IC-7800 oder Yaesu FT-DX9000. Bob Heil writes 'it is wonderful on the KENWOOD TS-2000, 850, 870, YAESU FT-1000 Mark V, and all of the ICOM PRO models as well'.
The PR-781 uses a dynamic microphone module from the professional studio series by Heil, which offers a wide frequency response and a high dynamic range. If you already own another microphone stand with shockmount by Heil you can use that with the PR-781 as well.
Additionally required is a connecting cable like the CC-1-XLR-x.

  • Technical Data
  • Heil Sound PR Dynamic Element
  • Frequency response 15 - 16000 Hz
  • Low weight aluminium membrane
  • Output level -55dB
  • Impedance 600 Ω
  • Steel case with black finish
  • Weight approx. 425g
Order No.
PR-781 PR-781 Microphone 200.00 € Buy now
PR-781.GOLD PR-781 Microphone in gold 224.00 € Buy now
Info freight charges

GM-Elite Goldline Microphone


A studio microphone by design but this special version is in particular well suited for modern all-band/all-mode transceivers. Requires CC-1 or CH-1 adaptor cable.

Order No.
GM-ELITE with Studio cartridge and HC-5.1, without cable 206.00 € Buy now
Info freight charges

Accessories for Heil Microphones


Cables for PR-780/PR-781

CC-1-XLR-x is used for the HEIL PR-780/781 verwendet. These cables are available with 8 pin round Foster connector for radios by Icom, Kenwood and Yaesu. The radio side has a 6.3 mm phone plug connector for a PTT switch. The microphone connector is 3 pin XLR.

Note:
When using the PR-781 microphone with transceivers as the FT-950, FT-2000 or FT-5000, it can happen that you have some interferences on transmit. To prevent this Heil recommends a special balanced transceiver cable, CC1-XLR-YBAL.

Order No.
CC-1-XLR-K for Kenwood 44.90 € Buy now
CC-1-XLR-I for Icom 44.90 € Buy now
CC-1-XLR-Y for Yaesu (see Note!) 44.90 € Buy now
CC1-XLR-YBAL for Yaesu FT-950, FT-2000, FT-5000 44.90 € Buy now
Info freight charges

Note:
For transceivers as the FT-950, FT-2000 FT-5000, when using the PR-781 come with the "normal" cables to interference. For this we offer an extra transceiver cable.

CC-1 Cables

CC-1-xxx can be used for all Heil handheld mikes with 4 pin XLR connector (Goldline, HM, Handimic). These cables are available with 8 pin round or modular plug for various rig types (Icom, Kenwood und Yaesu). These cable do have an additional PTT connector (6.3 mm phone jack) for a PTT switch.

Order No.
CC-1-I-8 mic cable, 8 pin round connector for ICOM 44.90 € Buy now
CC-1-I-M mic cable, 8 pin modular connector (RJ-45) for ICOM 44.90 € Buy now
CC-1-Y-8 mic cable, 8 pin round connector for YAESU 44.90 € Buy now
CC-1-Y-M mic cable, 8 pin modular connector (RJ-45) for YAESU 44.90 € Buy now
CC-1-K-8 mic cable, 8 pin round connector for KENWOOD 44.90 € Buy now
Info freight charges

CH-1 Cables

Bild CH-1

CH-1-xxx can be used with all Heil handheld mikes with 4 pin XLR connector (Goldline, HM, Handimic). Coil cord approx. 15" coil, 14" straight. These cables are available with 8 pin round or modular plug for various rig types (Icom, Kenwood und Yaesu). The cables with 8 pin round connector have a connector for a PTT foot switch (6.3 mm phone jack, like CC-1-xx), the cables with 8 pin modular plug don't have this connector.

Order No.
CH-1-I8 mic cable, 8 pin round connector for ICOM 33.50 € Buy now
CH-1-IM mic cable, 8 pin Modular (RJ-45) connector for ICOM 25.00 € Buy now
CH-1-K8 mic cable, 8 pin round connector for Kenwood 33.50 € Buy now
CH-1-KM mic cable, 8 pin Modular (RJ-45)connector for Kenwood 25.00 € Buy now
CH-1-Y8 mic cable, 8 pin round connector for Yaesu 33.50 € Buy now New
CH-1-YM mic cable, 8 pin Modular (RJ-45)connector for Yaesu 33.50 € Buy now
Info freight charges

Adaptor 8 pin round to RJ-45 modular

This special adapter converts the modular input of several rigs to the familiar 8 pin male Foster plug that will mate with all of our AD-1 adapters and CC-1 Microphone Connecting Cables. The adaptor brings out the Mic audio, Mic Shield Ground, PTT and PTT ground. This interfaces perfectly with our HMM-Y hand microphone, CC-1Y connecting cables for the HM-10 or Goldline microphones as well as the AD-1 Y adapters for the BM-10, PRO-SET or PRO-SET PLUS! headsets, or any of the Heil headsets.

Order No.
ADM-817 for Yaesu FT-817/857/897450 40.30 € Buy now
Info freight charges

Heil CB-1-PTT Microphone stand

CB-1PTT Bild
CB-1-PTT

Heavy microphone base not only for the PR-781. Includes PTT key and cable with 6.3 mm connector, fits directly to adaptors AD-1-xx and CC-1-xx-.

Order No.
CB-1-PTT 90.90 € Buy now
Info freight charges

PL-2T

Mikrophone boom for all Heil microphones. Can be installed with supplied clamp on desk or sideboard. Rotates 360°. Picture shows PL-2T with GM-5 (not included) and SM-1 (not included).

Order No.
PL-2T 155.00 € Buy now
PL-2TXCLAMP 25.00 € Buy now
PL-2TXWEIGHT 10.00 € Buy now
Info freight charges

HB-1

HB-1

The Heil HB-1 is an articulated arm built of very substantial steel channel structure and balanced by four external springs. It is capable of supporting microphones up to 1.3 kg. The boom moves freely and quietly. It is the perfect for Podcast, Amateur Radio and Commercial Radio studios. The HB-1 is shipped with a standard brass lined 'C' clamp mount with a 50 mm span width. The channel is designed so a small diameter microphone cable can be hidden and connectors soldered to each end. The HB-1 Boom accepts all of the standard 5/8" -27 threaded microphone clips on to the chrome stem. (The PR-781 microphone shown above is not included).

Order No.
HB-1 Microphone Boom 78.80 € Buy now
Info freight charges

SB-2

Short boom
For situations where the PL-2 boom is too large... with clamp for mounting on a table or board. Length adjustable between 30 and 52cm, with cable feed.

Order No.
SB-2 62.10 € Buy now
Info freight charges

SM-1

SM-1 Shock Mount Assembly
Can be used on all booms or stands. Professional shock mount is a unique design. The mic clip is suspended from 8 points using a neoprene elastic cord assembly, suspending the microphone from a direct mount, thus isolating the low frequency acoustical coupling to your desk. Picture shows SM-1 at PL-2T (not included) with GM-5 (not included).

Order No.
SM-1 67.90 € Buy now
Info freight charges

SM-2B

Heil Shock Mount SM-2

Shock mount for microphones
Can be used on all booms or stands. Professional shock mount is a unique design. The mic clip is suspended from 8 points using a neoprene elastic cord assembly, suspending the microphone from a direct mount, thus isolating the low frequency acoustical coupling to your desk. Suitable for PR-30, PR-40, PR-780, PR-781.

Order No.
SM-2 132.30 € Buy now
Info freight charges

FS-50

Footswitch (noname, not by Heil) with rubber coating, includes cable and plug, suitable for all AD-1 and CC-1 adaptors.

Order No.
FS-50 14.90 € Buy now
Info freight charges

FS-2

Large foot switch, two different keying ports, one closes earlier than the other.

Order No.
FS-2 63.30 € Buy now
Info freight charges

FS-100

Massive footswitch with 6.3 mm jack for direct connection to the HEIL Adapter cable. In the small switch the foot remains on the ground and push the button with either the heel or the toe. Between the passages the position will inevitably lead to a spasm of the foot. With this switch the whole foot is on the switch and by a slight rocking motion, the PTT is pressed.
The switch has 3 holes so you can still screw it additionally fixed on a board or similar.

Order No.
FS-100 Heavy Duty Foot Switch 29.50 € Buy now
Info freight charges

Heil Handswitch HS-2

Bild HS-2

The Heil 'Magnum' Hand-Switch PTT
Ergonomically correct, it's shape fits the hand naturally and comfortably, activating just like a pistol trigger.

HS-2 Features:

  • Ergonomic design
  • Very light touch trigger switch
  • Terminates into a 1/4" phone plug which connects into the Heil AD-1 or CC-1 cables.
  • Using a very reliable 15 amp MicroSwitch
  • Chrome spring cable grommet (just like you Mom's old iron!)
Order No.
HS-2 44.90 € Buy now
Info freight charges

Heilwire Microphone Cable New

microphone cable Heilwire (40014)

The 'Heilwire' is a custom made microphone cable which carries a shielded and an unshielded wire pair. The wires have a size of 0.8 mm² (AWG 18), the shield is made from very dense silver coated copper wire. The shielded pair is used for the microphone audio signal, the unshielded pair is used for switching purposes like PTT or other signals. Due to the separation of the two wire pairs mutual influences are effectively suppressed, the shield protects against HF irradiation into the microphone line. The outer jacket is made from highly flexible PVC, the diameter of ~6.5 mm is ideal for the connectors for Heil microphones and other audio connectors.

Order No.
40014 Heilwire, per meter 4.90 € Buy now New
Info freight charges

Spare Parts for HM-10 and GM-4/5 Microphone

Bild HM-10 Clip
Microphone clip
Order No.
HM-10CLIP for HM-10 and GM-x 11.30 € Buy now
Info freight charges
Bild HM-10 Windschutz
Wind screen
Order No.
HM-10WS-GM for HM-10 and GM-x 11.80 € Buy now
Info freight charges