IC-7600

In the tradition of the top-of-the-line transceivers IC-7800/IC-7700 Icom now offers the IC-7600. The receiver is a double superhet design with IF DSP, resulting in a much better intermod free dynamic range. Icom claims 104 dB dynamic range and an IP3 of +30dBm. Equipped with two 32bit Digital Signal Processors (DSPs) the receiver has two AGC loops, one analog, one digital. This results in a perfectly controlled gain control.

Three selectable 1st IF roofing filters (15, 6 and 3 kHz) provide a very good selectivity, especially at SSB and CW modes. The other IF filters are - as usual - freely programmable, due to the DSP design. THree filters can be programmed for each mode. With the well known twin passband tuning a fine tuning of the optimal bandwidth is possible during operation.

The IC-7600 offers the possibility to listen to two frequencies in one band at the same time (Dualwatch). This enables you to listen to the DX station on one VFO, and to the pile-up on the other.A must have for the serious DXer.

And the powerful signal processors offer many more functions, for example an effective noise cancellation, a variable noise blanker, automatic or manual notch filters with three selectable bandwidths, voice recorder functions for receive and transmit and much more. A precise TCXO (temperature controlled crystal oscillator) is factory installed, resulting in a very high frequency stability of ±0.5ppm. Especially digital modes like PSK31 etc benefit from this high stability.

The large colour LC display (5.8") offers a wide viewing angle and is for the first time equipped with a white LED backlight. This greatly reduces heat and has a much longer life than traditional CCFL lights. The multi function meter does not only display transmit power and signal strength, but also current and temperature of the final amplifier, SWR, ALC and compression level and much more.

A USB keyboard can be directly connected to the transceiver, allowing operation in PSK31 and RTTY without a computer. Another USB interface on the rear offers the usual remote control functions plus the receive and transmit audio. This allows for a much easier computer/transceiver integration.

Many more improvements like a selectable amplifier keying (FET or relay), freely programmable band edges, a solid 100 W FET amplifier and much more turns the IC-7600 into the perfect HF transceiver for the ambitious radio amateur. And as usual with the best Icom quality!

Included in shipment are a handbook, hand microphone HM-36, carrying handle MB-121, a DC cable plus spare fuses and some hardware parts.

Order No.
IC-7600 3069.00 € Buy now
99FREQ Frequency Extension Please see note! 25.00 € Buy now
Info freight charges
Download: Product Brochure IC-7600 (PDF, EN, 5.6MB)
Download: Review of the IC-7600 by Adam Farson VA7OJ/AB4OJ (PDF, English, 840KB)

Accessories IC-7600

Order No.
CT-17 CI-V level converter 99.00 € Buy now
HM-36 - Hand microphone 56.50 € Buy now
SM-30 Desktop microphone 159.00 € Buy now
SM-50 Desktop microphone 269.00 € Buy now
SP-23I Icom Loudspeaker SP-23 265.00 € Buy now
PHITS-I23 Phonema Insulation Kit for Icom SP-23I 39.00 € Buy now New
DC-CABLE-HF4 DC-Cable 2.5m, with fuses (similar OPC-1457) 21.90 € Buy now
42914.I-TUN Connector for 'Tuner' socket 9.50 € Buy now
PS-126 25A switching power supply from ICOM 445.00 € Buy now New
DC-IC7600 Dust cover for IC-7600 39.00 € Buy now New
Info freight charges
Dust Cover DC-IC7600 Dust cover
PHITS-I23 PHITS-I23 Phonema Insulation Kit

You can see an overview of Icom desktop speakers here.

Icom RS-BA1 Remote Control Software

This transceiver can be operated remotely over the internet or a local network, using the RS-BA1 software. Detailled information about RS-BA1 software.

Order No.
RS-BA1 Remote Control Software 79.90 € Buy now
RC-28 Remote Control Unit 215.00 € Buy now
Info freight charges

Frequency Extension for Radios

Please note:
All radios supplied by WiMo normally cover only the amateur bands (transmit wise).

The frequency extension of a radio (TX open) is done on explicit request by the customer.

Amateur Radio transceivers are usually not specified for use outside the amateur bands. In some cases the radio and especially the final amplifier or output filters can be damaged when transmitting outside the amateur bands. These damages are not covered by any warranty.

The manufacturer warranty might be voided in some cases as well.