Lightning arrestors

Standard Series

Lightning protector from Diamond, ACI or Willsame for in-line use; the protector can be used in the coax cable directly at the antenna base or at the radio. Available as N- or UHF connector, female/female or male/male, with a solder lug for ground connection. Available for various power loads, see table.

Diamond SP-1000

Diamond SP-3000

G-601 NFM

G-601 Flange

The surge protectors No. 21045 and 21047 are water proof and can be used outdoors directly at the antenna. Please note: Normally the coax connectors are not waterproof; use coax seal (wrap it on like normal tape) 23065 and mold to fit!
The arrestors of the G-Series have a M4 thread for connection of a grounding wire. Additionally there are 4 drill holes on the female socket end for flange mount in a rack. A silicon wafer is included.

Type		SP-1000	SP-1000PW	SP-3000	SP-3000P	G601-NFF	G601-NFM
Max. Frequency:		1000	1000	2500	2500	3000	3000	MHz
Max. Power load (PEP)	0-30 MHz:	400	400	200	400	2000	2000	W
	30-500 MHz:	400	400	200	400	800	800	W
	über 500 MHz:	400	400	200	400	320	320	W
Insertion loss	500 MHz:	0,1	<0,2					dB
	1500 MHz:			0,1	0,1			dB
	3000 MHz:					< 0,2	< 0,2	dB
Breakthrough voltage (DC)		350	350	230	350	600	600	V
Connector		PL f/f	PL m/f	N f/f	N m/f	N f/f	N m/f
Spare fuse element		21042.02 10.61 (10.30) EUR	21042.02 10.61 (10.30) EUR	21043.02 10.61 (10.30) EUR	21043.02 10.61 (10.30) EUR	21045.01 12.36 (12.00) EUR
Order No.		21042 26.73 (25.95) EUR	21042.10 36.98 (35.90) EUR	21043 40.17 (39.00) EUR	21043.10 40.69 (39.50) EUR	21045 48.41 (47.00) EUR	21047 50.16 (48.70) EUR

Economy Series

21049.NMF

21049.NFF

21049.NSB

21055

Economy series without compromises on the electrical specs, not watertight. Available with various connectors, see table. Does not use exchangeable spare fuse elements, the complete system must be changed.

Type		21049.NMF	21049.NFF	21049.NSB	21049.BMF	21055
Max. Frequency:		3000	3000	3000	1000	2500	MHz
Max. Power (PEP)	0-30 MHz:	200	200	200	200	200	W
	30-500 MHz:	200	200	200	200	200	W
	> 500 MHz:	200	200	200	200	200	W
Insertion Loss	500 MHz:	0,1 - 0,2	0,1 - 0,2	0,1 - 0,2	0,1 - 0,2	0,1 - 0,2	dB
	1500 MHz:	0,3	0,3	0,3	0,3	0,3	dB
	3000 MHz:	0,4	0,4	0,4	0,4	0,4	dB
Breakthrough Voltage (DC)		350	350	350	350	350	V
Connector		N St/Bu	N Bu/Bu	N Bu/Bu Einloch	BNC St/Bu	TNC St/Bu
Order No.		21049.NMF 36.98 (35.90) EUR	21049.NFF 34.92 (33.90) EUR	21049.NSB 38.11 (37.00) EUR	21049.BMF 35.95 (34.90) EUR	21055 44.39 (43.10) EUR
Best.Nr. Spare fuse element		—	—	21049.NSP-PA 13.29 (12.90) EUR	—	—

Transmission 21049.NFF

Lightning arrestor 6 GHz

Directly inserted into the cable, connectors N (f/m).

Order No.
21060 70.04 (68.00) EUR

Wideband lightning protection 0-6GHz

21054

Breakthrough voltage 230VDC, Insertion loss 0.2dB @0-3GHz, 0.3dB @3-4 GHz, 0.5dB @4-6 GHz, panel mount.

New 21053.RTMF Lightning protector with Reverse-TNC plug (inner thread, female center pin) / Reverse-TNC jack (outher thread, male center pin). Suitable for the most antennas, cables and equipment by Cisco.

Overvoltage protection for control lines

Overvoltage protection 16 lines

You should not only protect a coaxial cable against lightning, but also a control wire, e.g. of rotors, switches and antennas like SteppIR beams. With the device up to 16 wires of a control line can be easily protected against overvoltage. Just install the box at the base of your tower or at any other well grounded point and pass each wire oven one of the screw terminals. High-grade metal oxide varistors protect each individual wire, additionally a capacitor protects again HF induction of your transmitter.

Order No.
21070 Over voltage protection 142.14 (138.00) EUR