Tiltable base for all mobile antennas with N or PL connector (WiMo, Diamond, Comet, Maldol...). The amount of tilt can be adjust up to 30 degrees from vertical. These mount are designed to be used on the fender or on the roof of the car. The cable has a length of 4m, different versions with cable mounted sideways or centrally are available. All metallic parts are chrome plated and weatherproof. Outer diameter is 30mm, drill hole diameter is 12 or 16mm.
Base mount for all antennas with PL connector. Very low profile, requires very little space inside the car roof (20mm). Complete with 4m cable.
Base mount for Mercedes-Benz W124 (not for T model), can be mounted in the existing hole in the fender. The original rubber grommets are required for installation.
The large surface of the mount makes it suitable for larger antennas like the ATAS-120 etc. Outer diameter 40mm, drill hole diameter 16mm, depth 20mm inside. Complete with 4m cable H-155, attached sideways.
Heavy base mount with 3/8" thread (female). 50mm outer diameter, drill hole diameter 16mm, internal connector PL.
DV base for roof mount, only 10mm depth inside the car. With 4m RG-58 cable attached, can also be mounted from the outside. Drill hole diameter 19mm.
DV base mounts in various models, with special connector Order No. 20002 or cable Order No. 20008. Not suitable for use on 70cm band.
Cable with 90 deg. angle connector for DV mount, length 4m.
Heavy Diamond magnet base with N or PL jack for any radiator with N or PL plug. Cable 4m long with N or PL connector. DIameter c. 11cm, high quality, also suitable for up to 23cm band.
Huge magnet base with c. 16cm diameter, very low profile. With PL jack, PL plug on cable. Very strong hold on flat car roof with the supplied rubber gasket. Cable 4m total length, first part (1m) is thin, low loss RG-188, remaining special low loss cable 7mm diamter.
Small Diamond magnet base with BNC jack for a radiator with BNC plug, with 3m cable with BNC plug. Excellent quality, also suitable for 23cm with the appropiate tri-band antennas.
Magnet base H12, low profile, fixed cable RG-58 attached, for all HF/VHF antennas with PL or DV connector. These magnet bases are not suitable for use on UHF (70cm, 430MHz).
 |
 |
 |
| DIAMOND MCR2 Universal BNC holder with knuckle, e.g. place it on the outside rear mirror. Includes 2.5m cable with BNC connector.
Order No.
20046 36.05 (35.00) EUR
|
||
 |
||
| BNC holder with alligator clip. Includes 1.5m RG-174 cable and BNC connector.
Order No.
20041 13.70 (13.30) EUR
|
||
Solid window clamp for any antenna with PL connector. The base can be tilted in any direction so the antenna can be adjusted vertically. LOcks on the glass, so the window can be opened without risk of losing the antenna. Internal connector BNC, includes a 3.5m cable with BNC and PL.
Window clamp for temporary use of a radio in a car, just place the rubber ducky of your handheld radio or any other antenna on the clamp. Includes 2m cable with BNC or SMA connectors.
 |
 |
| Diamond cable harness for trunk mounts with 4 or 6m cable. The first 30cm (100cm with M-610R) are made of very thin cable to fit through the lid, the rest of the cable is made of low loss 6mm cable.
Order No.
20052 S-410NN N jack (female) / N plug (male) 47.59 (46.20) EUR 20053 S-405MM PL jack (female) / PL plug (male) 35.02 (34.00) EUR 20054 S-510MN N plug (male) / PL jack (female), 5m 45.94 (44.60) EUR 20055 M-610R Pl plug (male) / PL jack (female), 6m 41.10 (39.90) EUR |
Diamond cable harness for trunk mounts with 4m cable, either PL or N connectors.
20050 ECH, PL connector 15.40 (14.95) EUR
|
New series for all puposes, all in a black anodized finish. Most mounts are tiltable in two directions. If can't drill a hole in the chassis, you will find a solution here. The suitable cable harnesses are shown above (Order No. 20051 - 20053.
| For | Small | Heavy | incl. cable |
| rear tunk lid | K-401 | K-400 K-402 |
K-600M |
| Roof railing / Truck mirror | K-501/K-515 | K-540/K-550 | |
| Roof railing | - | K-300 | - |
 K-401 |
 K-402 |
| Mini trunk mount, can be adjusted to any angle.
Order No.
20067 K-401 34.92 (33.90) EUR
|
Solid trunk mount for larger antennas, adjustable.
Order No.
20072 K-402 40.69 (39.50) EUR
|
 K-400 |
 K-540 |
| Solid trunk mount, black, for larger antennas. Adjustable in two directions.
Order No.
20069 K-400 30.39 (29.50) EUR
|
Solid mount for roof railing or tunk mirror. Adjustable without tools.
Order No.
20071 K-540 37.49 (36.40) EUR
|
 K-300 |
 K-600M |
| Solid roof railing mount, adjustable by hand, black like all Diamond mounts.
Order No.
20074 K-30035.84 (34.80) EUR
|
Very low profile trunk mount includes PL base and 5m cable with PL connector.
Order No.
20065 K-600M 60.26 (58.50) EUR
|
  |
  |
| Solid roof railing antenna, for irregular shaped railings (not round). The flexible belt adjusts to any shape of the railing. Can be tilted in two directions.
Order No.
20070 K-550 45.94 (44.60) EUR
|
Roof railing mount for large railings
Order No.
20075 K-501 34.92 (33.90) EUR
|
 K-515 |
 |
| Variable roof railing mount, max. size see right
Order No.
20076 K-515 39.66 (38.50) EUR
|
K-515 Spans max. 48mm horizontal, max. 50mm vertical
|
Stainless steel, for mounting our cable sets 20050 etc. to a car or motor bike sign plate (check your local vehicle regulations!) or at any other place.
Option: Mast clamp for mounting on a vertical pole or mast, consisting of U bolt, bracket, lock washers and nuts. All stainless steel!
 Adaptor PL259/ 3/8" e.g. for magnet base or similiar, heavy duty model, chrome plated.
Order No.
30007 7.93 ( 7.70) EUR
|
 Adapter PL259/DV, for DV radiators on a PL base, chrome plated.
Order No.
30012 11.64 (11.30) EUR
|
 Adapter PL259/DV, as 30012, economy model, nickel plated.
Order No.
30013 8.76 ( 8.50) EUR
|
 BNC adaptor with thread M8 x 0.75 for FT-290, TR-2300 or similiar.
Order No.
30009 6.18 ( 6.00) EUR
|
 DV adaptor with PL or N jack (female) for antennas with PL or N base on a DV mount.
Order No.
30010 PL jack 10.30 (10.00) EUR 30010.01 N jack 11.12 (10.80) EUR
|
 Self adhesive cable guide for RG-58
Order No.
40016 0.52 ( 0.50) EUR
|
 Connector for DV base, 90 deg. angled, RG-58
Order No.
30001 2.58 ( 2.50) EUR
|
 Wing nut for DV mounts
Order No.
30002 1.55 ( 1.50) EUR
|
 Theft protection for antennas with DV base
Order No.
30003 2.47 ( 2.40) EUR
|
 Adaptor DV to 3/8$quot; for all antennas with 3/8" base.
Order No.
30004 5.25 ( 5.10) EUR
|
 Euro adaptor, mounting a DV base antenna on a 3/8" mount.
Order No.
30005 3.09 ( 3.00) EUR
|
 Thread bolt 3/8" 25mm, stainless steel
Order No.
30011 2.68 ( 2.60) EUR
|
 Cover for drill holes
Order No.
40006 12-16 mm diameter 6.90 ( 6.70) EUR |
 Protective caps for PL or N base, e.g. the base mounts. Protects the jack when antenna is not mounted. Brass, chrome plated.
Order No.
30014 3.81 ( 3.70) EUR
|
| Diese Seite drucken | Diese Seite zu den Favoriten hinzufügen |