PicoAPRS with GPS receiver (Kit)Nuevo
"Worlds smallest APRS transceiver with TNC" offers many applications. Matchbox-sized, built-in GPS receiver.
The transceiver can not only be used as APRS tracker and receiver for APRS data, but also as TNC (KISS protocol) for computer.
The graphical OLED display (128x64 pixel) shows received APRS packets such as position reports, APRS messages and status information.
When receiving position reports the distance and cardinal direction to the sender is shown.
Each of the four most recently listened in stations, including distance and cardinal direction as well as received messages are saved and can be retrieved via menu.
The own GPS coordinates are also shown, allowing the PicoAPRS to be used as a GPS receiver as well, for example for Geo Caching.
It's possible to save a fixed GPS position. This position is used when GPS positioning is not working. The fixed GPS position is then only used to show distance and cardinal direction of received stations.
All handling is done with two push buttons. With the help of a versatile menu system the transceiver can be individually configured and operated without using a computer.
The device comes almost fully preconfigured. Just save the call sign and you're ready to go.
The transmit power is approx 1 Watt and can be switched down to 0.5W. The own position data is transmitted as a compressed MIC-E APRS message to keep transmit duration as short as possible. This also helps to save battery power. Of course received messages in compressed MIC-E can be decoded and displayed as well.
The built-in 850mAh LiIon battery allows operation up to 10 hours* depending on configuration.
The HF receiver can be deactivated to save a lot of power, the Pico-APRS then functions as a pure APRS tracker. To extend battery lifetime even further the GPS receiver can be turned on and off in programmable intervals and the display can be dimmed.
The built-in micro USB connector is not only used to charge the built-in battery and for upgrading the firmware, but also to use the tranceiver as a USB-GPS mouse or as a TNC at a computer. This allows you to set up your own APRS Digipeater or iGate in a breath! We will provide a guide for this in the near future.
The transmitter utilzes a 7-pole low pass filter to suppress unwanted harmonics. The main processor is well known from the Arduino world, it's an ATmega 1284p. The current software uses less than half of the available memory, this allows for a lot of further developments in the future.
The tiny size of just 33 x 58 x 24 mm is close to that of a matchbox. The weight (without antenna) is just 52 gram. This is perfect to carry the Mini APRS Transceiver with you all thetime, whether on a hiking trip, on a journey with your bike or boat or even when skiing.
Version 2 of the PicoAPRS now has an acoustic buzzer which is used for key tones and signaling of received packets. Additionally the hardware was extended for accomodate a charge current display. A new firmware makes use of these innovations and offers other, new functions, see below. Older devices can use this new firmware as well, but the charging current display won't work.
- New functions Version 2:
- Dispaly of charging current
- Automatic on/off function when power is applied or removed from the USB socket, useful when using the PicoAPRS on a cigar lighter cable in the car.
- Home position can be stored in EEPROM and recalled when no GPS reception is possible
- Disable transmit intervals completely, e.g. for use as receive only pager
- improved decoding of packets
- Selection of distance units as miles or km
The Pico-APRS was developed by Taner Schenker (DB1NTO).
*) Depending on how frequently the position data is to be sent, whether APRS packets are to be received, whether the GPS receiver should be switched off automatically when not in use, and how often the display can be switched off
- Menu items (to be extended):
- Device off
- Recently listened in stations
- Received messages
- APRS symbol
- GPS status and display of GPS data: coordinates, absolute altitude, Maidenhead (QTH) LOCATOR, GPS date, number of staellites, course
- USB mode (AUS, GPS, TNC)
- Save current position as "default position"
- Transmit power (1 Watt / 0.5 Watt)
- Send Beacon
- Time zones for adjusted displayed time
- MyCall, SSID
- Receiver exchange ON/OFF (OFF = just tracker for sending position report)
- Autoclose (closes received messages after an adjustable time automatically)
- Display timeout ("screensaver")
- GPS power saving (ON/OFF)
- Display contrast (low / high)
- APRS comment text
- Information display
- Included in the shipment (kit):
- Enclosure with keys
- Set of printed circuit boards, fully populated and tested
- LiIon battery
- Pin header for GPS board
No charger or antenna included. Thanks to the standard micro USB connector, the charger of any newer mobile phone can be used for charging.
Alternatively, charge with any USB charger or USB port of a PC. For suitable USB cables see accessories list.
Any antenna with SMA connector can be used as an antenna, for some recommendations see accessories list. The tiny device makes you want to use a tiny antenna as well... but small antennas have a comparatively poor efficency, of course, and we only have 1W of transmit power. When used in a vehicle, an external antenna is recommend, for example a magnet base antenna.
The device is supplied as a kit. The two circuit boards must be mounted on each other and installed in the enclosure. The circuit boards are completely equipped and tested.
|PICOAPRS||PicoAPRS Kit||199.00 €||Comprar||Nuevo||Disponible, envio en 1 o 2 diás. ▶|
|Gastos de envió|
Download: Bedienungsanleitung (PDF,DE,1400 KB)
Download: Manual (PDF,EN,1550 KB)
Mount for PicoAPRS. Can be attached anywhere thanks to the included Velcro strip. The USB port stays accessible.
|PICO-CLIP||Mount for PicoAPRS||15.80 €||Comprar||Disponible, envio en 1 o 2 diás. ▶|
|Gastos de envió|
Recommend equipment and magnet base antennas
|17027||DIAMOND SRH-1 equipment antenna, length 2,5cm||18.00 €||Comprar||Disponible, envio en 1 o 2 diás. ▶|
|17023||DIAMOND SRH-805 equipment antenna, length 4,5cm||18.50 €||Comprar||Disponible, envio en 1 o 2 diás. ▶|
|17021||DIAMOND SRH-815S equipment antenna, length 15cm||21.00 €||Comprar||Disponible, envio en 1 o 2 diás. ▶|
|17022||DIAMOND SRH-36 equipment antenna, length 36cm||31.00 €||Comprar||Disponible, envio en 1 o 2 diás. ▶|
|20117.SMA||DIAMOND MR-77S magnet base antenna, 4m cable, base 65mm diameter||36.00 €||Comprar||Disponible, envio en 1 o 2 diás. ▶|
|20119.SMA||DIAMOND MR-75S magnet base antenna, 3m cable, base 30mm diameter||31.50 €||Comprar||Disponible, envio en 1 o 2 diás. ▶|
|20111.SMA||No-name magnet base antenna, 3m cable||22.90 €||Comprar||Disponible, envio en 1 o 2 diás. ▶|
|40074.06||USB/Micro-USB cable, 60cm||3.90 €||Comprar||Disponible, envio en 1 o 2 diás. ▶|
|40074.1||USB/Micro-USB cable, 100cm||4.50 €||Comprar||Disponible, envio en 1 o 2 diás. ▶|
|42854.02||Adapter SMA-plug(m)/BNC-jack(f), ultra short, black||11.40 €||Comprar||Disponible, envio en 1 o 2 diás. ▶|
|35050||Secondary battery LiPo 3,6V/850mAh||8.50 €||Comprar||Disponible, envio en 1 o 2 diás. ▶|
|35051||USB battery charger||8.50 €||Comprar||Disponible, envio en 1 o 2 diás. ▶|
|Gastos de envió|
USB charger to charge spare batteries without the device.
A maximum of 4 batteries can be charged simultaneously, with charge control indicator. Requires a USB connector as power supply.
Customer Feedbackto the PicoAPRS
A customer write in December 2016
From: ON8SD To: WiMo It was worth the waiting! PicoAPRS, the smallest APRS-transceiver in the world is working like a charm! DB1NTO had done a fantastic job! Next stop, trying to find a good antenna to get the most of the 1W output because this one has to become an emergency device while trailrunning ! ON8SD