Here you will find:
Padded, solid nylon bag with zipper and hook, suitable for all ATX antennas and other similiar sized antennas. Sizes 33 x 6 x 4 cm.
Mono band radiators with BNC connector, available for all traditional bands from 80 to 10m, transport length 26cm, extended length 1.4m, power max. 20 Watt.
|
|
The Wonder Wand provides a simple and efficient means of improving the performance of you portable HF amateur radio transceiver when compared to the antenna normally supplied with the set. Operation is simplicity itself.
The Wonder Wand has been made as compact as possible, without compromising performance. Just pop it in a bag with your rig when going for a walk in the countryside or take it camping. Enjoy radio in the great outdoors without the hassle of erecting more complex antennas.
Designed with the Yaesu FT 817 and FT 897 in mind, the Wonder Wand can also be used on other low power HF radios up to a maximum output power of 25 watts P.E.P. The new MKII Wonder wand features a 1.3m black whip and a higher Q toroid for even greater performance.
HF Operation
Connect the Wonder Wand directly to the antenna SO239 socket on the rear of your radio. If the radio has a selectable front / rear antenna function don't forget to select the rear socket. Extend the telescopic whip to its maximum length and then position it away from both obstructions and yourself.
Rotate the knob on the rear of the unit to select the desired band of operation between 7Mhz and 50Mhz. The unit is pre-tuned for optimum match on each band so no further adjustment is necessary.
VHF / UHF Operation
For VHF and UHF operation between 50Mhz and 440Mhz the tuning circuit is switched out, the unit becoming a simple whip antenna. It is then necessary to adjust the length of the telescopic whip to obtain the best match on the desired band. This is normally obtained by adjusting the length of the whip to an odd multiple of quarter wavelengths measuring the distance from the PL259 connector on the Wonder Wand.
Wonder-Wand TCS
Tunable Counterpoise System
The Wonder-Wand TCS is a portable ground radial system designed to plug into the 4mm socket on the side of the Wonder-Wand antenna, although it will also work very well with other types of antenna. Quite simply it is a tuning box that interfaces the chassis of the radio to a short 4m counterpoise which is extended out over the ground. The best setting is determined by rotating the control from A - L until a definite increase in received signal is heard. It also has the same effect on transmit.
Wonderwand Combo
The Wonder Wand Combo combines the portable antenna unit and tunable counterpoise.
The Wonder Wand has been made as compact as possible, without compromising performance and the Combo is the new member of the family. Just pop it in a bag with your rig when going for a walk in the countryside or take it camping. Enjoy radio in the great outdoors without the hassle of erecting more complex antennas.
The unit can be used with or without the counterpoise wire and good match to the TRX is maintained in both situations, although like any other antenna system it will perform better with the ground wire connected.
In most situations the telescopic whip is fully extended on all HF bands covered unless a substantial ground system is employed.
Wonderpole
Wonderpole is a compact symmetrical dipole for 14 to 28 MHz which is connected directly to the antenna socket of a radio. Extended length nearly 3m, retracted only 30cm, dipole elements with knuckle. Tuning is done like with the Wonderwand (see above) by choosing the best position of the tuning switch, no counterpoise required.
Suitable for FT-817, 857, 897, IC-703, Elecraft K Series and nearly and HF radio with PL socket. Max. power load is 40W.
Frequency range: 7/14/21/28/50/144/430MHz, Max Pwr input: HF/50MHz: 100W (SSB/CW), 50W (AM/FM), 144/430MHz: 50W (All mode) Height Max 2.2m, 0.6m for transporting * Weight: 930g. Supplied with radiating elements, radial elements for VHF/UHF, radial wires + spare radial wire, Allen key.
The ATAS-25 utilises a manual tuning system which resonates the radiating element for lowest SWR without the need for expensive mono-band resonating whip assemblies. It allows dual frequency operation on HF or 50MHz and either 2m or 70cm (duplexer not supplied). A very handy feature is that the ATAS-25 is designed to mount directly onto a standard camera tripod mount (not supplied) and makes up a portable antenna system ideal for tempory field operation but not recommended for long-term outdoor installation.
For some models, you may wish to purchase a diplexer or triplexer to avoid moving your cable from one antenna jack to another. When using the ATAS-25 with the FT-817, set Menu #07 to REAR for all bands.
The Buddipole is a professionally constructed portable antenna for 40 to 2m which has found a huge popularity worldwide. The exceptionally good quality and care of details make this antenna an ideal companion for vacations and other portable activities. The transport length of the dipole is only 56cm, with a weight of only 900g nearly any pole is suitable for carrying it. A coaxial cable (380cm) with PL and BNC connectors is supplied, equipped with a choke on the antenna side. Power rating: 250W.
The VersaTee center allows mounting of the dipole with 3/8" threads in 'L', vertical and straight setup. With the optional 'Rotating Arm Kit' (RAK) the dipole elements can be adjusted in 'V' form with nearly any angle. The VersaTee center is mounted on any pole with a 1/2" thread (painters pole, broomstick or the Buddipole masts).
The performance of the Buddipole is excellent: the center loaded coil offers much less losses as other designs. Very enthusiastic user reports show that DX results are easily achieved, even when working QRP.
Included in Buddipole
This is what Buddipole says about the specified power rating of 250 watt:
"This rating is very very conservative. We actually run the Buddipole with 500w on sideband without any problems. One must only be careful to watch the RF off the tips of the antenna. We say 250w to be safe. We did run a full KW through the Buddipole and felt the beads in the coax assembly get hot, as well as the coils! But the antenna continued to operate just fine after a minute or two on SSB."
For those asking for even more convenience we offer the Buddipole Deluxe Kit. It contains the Buddipole, a lightweight aluminium mast (240cm), a tripod, an additional radiator, extra coil clamps and the 'rotating Arm Kit' which allows the arbitrary orientation of the dipole elements. A solid nylon bag completes this kit. With this Deluxe Package you have all items at hand, which a required for a protable antenna. The Buddipole Deluxe Package weighs under 5kg and has a transport length of 61cm.

Buddipole Deluxe Kit includes
Tripod and either mast (long or short) are available separately as well and can be used with any antenna. This will provide you with a very compact portable mast with 240 or 480 cm height.
You will require the tripod article 11420.BPT and the short (article 11420.BM) or long (article 11420.BML) mast. Or both?
These are the new low band coils which perform on frequencies to 3.5 mhz.
These coils are best utilized for medium DX contacts in a vertical configuration with single sloping counterpoise. A counterpoise of 20m is recommended.
In the dipole configuration with 2 coils it is recommended to add additional length to the antenna to cover all of the 80m band and to increase bandwidth. Our new long telescopic whips accomplish this.
Because of the high-Q of the coils and the short overall length of the dipole antenna for the low bands, bandwidth is minimized. In order to be able to have some tuning flexibility within the band it is recommended to use a small tuner at the transceiver.
In either the vertical (one coil) or dipole (2 coils) configuration it is necessary to use a balun with significant choking impedance to prevent RF feedback. Our TRSB (Triple-Ratio Switch Balun) is an excellent product for these applications.
These new whips are longer in length -- nearly 10 feet overall! This is an additional 4 feet extra over the standard whips. Used with our Buddipole the overall length of the antenna increases from 16 feet to 24 feet! This additional length increases bandwidth and efficiency, particularly on 40 meters.
As with all of our whips, the base sections feature a double set of crimps which prevents the base section from breaking out under the stress of deploying the antennas in a horizontal configuration.
Collapsed length is 53cm, same as the antenna arms. Extended length is 290cm.
Multiband vertical antenna for 10 to 40m, max. 250W. Comes in a solid carrying bag, a set of radials in included.
The Buddistick is in principle half of a Buddipole... if you already have a Buddipole, all you need is the optional vertical mount.
The antenna has a mount plate included which fits on a usual photo tripod. A clamp is available optionally. Connector PL female.
Very small transport bag (included)
The Buddistick Deluxe is a complete set of all part, ready for immediate use. Included is:
|
HF portable antenna for 3.5 to 30MHz incl. WARC bands, max. power 100 Watt, so not only suitable for QRP rigs. 130c, long telesopes with exchangeable extension coils for each band, center part with short mounting tube and mast clamps, mounts easily on a balcony or any other provisional device. Connector PL. Extension kit
Extension kit for XR-100, includes one mast peg with center part, mast clamps and two telescopes. With the existing coils a separate antenna for another band can be installed. |
The amateur bands 40, 20, 15, 10 and 6m are available at the same time, in contrast to DP-7RH (see below) not change of parts necessary.
The antenna has individual tuning elements for each band, reducing influence between bands. With it's small weight of only 1.95kg and the span of 4m this antenna is ideally suited for vacation use, or - under restricted space conditions - useful at home, e.g. on the veranda.
Max power load 150 Watt, with balun 50 Ω, connector PL jack. All mounting hardware (stainless steel) for masts from 25 to 62mm included.
![]() |
Frequency range 7 to 30MHz, consists of stainless steel teelscopes and three sets of extension coils, covering all bands for 40 to 10m incl. WARC. Includes 1:1 balun, connector PL. Max. power load 100 Watt, total length 360cm, transport length only 38cm. The included BU-50 balun has a max power rating of 1200 Watt and can be used separately for other antennas. |
![]() |
The MP-1 is a universal antenna with 180cm length and max. 150 Watt power load. The center loading coil is adjusted with a sliding tap, just move the outer part of the coil up and down. The antenna has a 3/8" thread bolt for mobile use, suitable for the appropiate base mounts. For use while driving the telescopic part of the antenna should be replace with a steel whip (available optional). For portabale use a universal base with PL connector and a ground radial kit is included.
Without the center loading coil the antenna can be used on 2m and 70cm by adjusting the length of the telescope. The standard version covers all bands from 7 to 30MHz, for 80m operations an optional extension coil is available.
Especially for hte FT-817 a special mounting bracket is available which can be bolted to the side of the radio. The antenna is connected with a short PL cable (not included).
Consists of a conical stainless steel whip (length 125cm) which replaces the teescope, and a longer lower part (length 65cm).

Shortened dipoles for 160 to 6m. Total length around 360cm, transport length about 120cm, max. power 500 Watt PEP. Center part made of glass fibre reinforced nylon, connector PL female.
Nice companion for existing antennas or as a portable antenna. Two different center parts, straight or dual band one, are available. The dual band center part allows two different dipoles to be used the same time on any two bands.
Included with the center part is a short mast tube (500mm x 32mm dia.), allow-ing easy mounting to any vertical mast. Use mast clamps 23001 (not inluded) for easiest installation.

Note: To order this antenna, order two items: the center part and at least one set of dipoles.



Small and lightweight antenna for restricted space situations and portable operations, works on 40 to 10, 6m and 2m. Use anywhere, on a balcony, on the window sill, on the camper... Collapsed only 57cm long, weight only 1.4kg, fits in onboard air luggage.
The antenna is made of a stainless steel telscope with loading coil, installed on a aluminum bracket. This bracket can be mounted on any surface for easy installation.
Included is a 10m long counterpoise with taps for each band. For operations the loading coil is shortened at certain taps, equally the counterpoise is unrolled to individual markings. Wit hsmall power the SWR can be adjusted precisely. Max. power load is 300 Watt PEP SSB, total length of antenna approx. 180cm.
5 band QRP portable antennas
The RHM-5 / RHV-5 antennas are useable on 40, 20, 15 10 and 6m, to change bands one element has to exchanged or adjusted. Max. power load 20 Watt, weight only 280 gram, extended length 155cm, collapsed only 60cm. Model RHM-5 is equipped with a steel telescope, the model RHV-5 with a glass fibre whip, ideal for backpacking. Fits directly on QRP rigs like FT-817, IC-703 or similiar (see picture on the right).
Use it as an antenna by itself (10/12 and 15 Meters) or use it on top of a screwdriver antenna to greatly improve it's efficiency. Use it on many base-loaded antennas to extend coverage (10-80 Meters). Use it to make portable dipole antennas. Use it for any antenna purpose you want, but DON'T use it when driving!! Hex base threaded 3/8 x 24 stub.
| Diese Seite drucken | Diese Seite zu den Favoriten hinzufügen |