PR-12 Antenna Rotator 12V
€399.00incl. 19% VAT plus shipping
Not available until further notice, delivery delay unknown.
Antenna rotator for 12V battery operation. The PR-12 consists of two parts: the actual rotator, which despite its small size is able to rotate light 3-element portable beam, and the separate control unit with operating elements and LC display. The rotator has a rotation time of 1 minute and is driven by a self-locking worm gear. The motor is PWM controlled for smooth starting and stopping.
Inside the control unit a microcontroller works, it polls the operating elements, controls the motor and beam direction and shows other information on the display. Individual parameters like directional calibration are permanently saved even after power off. The rotator can be controlled remotely via USB interface; for remote control the Yaesu interface 'GS-232' is emulated, which is supported by most logging programs. The software is updated via USB interface, too. Special emphasis was placed on the fact that the motor control does not cause any radio interference.
The device is operating with 12V, power consumption during rotation is (depending on load) about 1A, idle 40mA.
It comes with a 16m long control cable, USB cable as well as the DC cable, mast clamps for pipe mounting up to 40 mm diameter, a small compass as well as the English manual. Options for Buddipole antennas are available, see below.
You can easily make your own connector cables. All you need are plug/socket 42007.04, 42009.04 as well as the 6-wire control cable 40012.6.Tip: Shunt 2x2 wires across and use them as connectors to the motor.
|Short Description||PR-12 Antenna Rotator 12VDC|
|Title||PR-12 Antenna Rotator 12V|