ID-RP-4000V D-Star Repeater
Unfortunately this product is not available anymore. Sorry.
- HF unit 70cm (in 19 "-2U housing)
- Power cable for 13.8V, 1m
- Programming software
- Support feet (4 pcs.)
- Data cable to the controller 1m
To set up a D-Star Repeater a controller ID-RP2C and at least one HF part for user access is required. Icom offers HF parts for 2m (), 70cm () and 23cm ( (Voice), (Data)). In addition there are 10GHz Interlink systems (ID-RP2L) for networking several D-Star Repeaters to a complete system. These 10GHz components are not approved for Europe and are not offered by WIMO.
To operate the D-Star Repeater with optional internet gateway a PC is required (not offered by WiMo).
For setting up the repeater a PC with Windows is required.
The modules ID-RP2000V, ID-RP4000V and ID-RP2V are HF units for voice and slow data (DV mode, 1.2kBits/s) for 2m, 70cm and 23cm respectively. These modules contain separate transmitters and receivers, which are freely programmable in the frequencies. The transmitting power is switchable via a switch accessible on the front side. At the rear side two N-sockets (Rx/Tx) are available. The operating voltage is 13.8V.
The ID-RP2D is the RF part for 23cm data (DD mode, 128kBit/s). This module is a simplex device, i.e. it does not work with a frequency offset, but only on one transmit/receive frequency. Therefore no T/R crossover or similar is to be provided.
If the DV mode repeater is to be operated with a common antenna for transmission/reception, a T/R crossover with the highest possible blocking attenuation (≥ 100dB) must be provided (not included in the scope of delivery). If the repeater is to be operated with separate transmit and receive antennas, appropriate filters with the highest possible attenuation are required (not included).
Please note that the HF parts can only be operated together with a controller .
|Size W x H x D||483 x 88 x 428 (19"|
|Weight [kg]||7.50 kgs|