Icom IC-7300

Icom IC-7300

incl. VAT plus shipping €990.76
EU VAT reform as of 01.07.2021: X

As part of the so-called "Digitalpaket", the introduction of a new VAT system with far-reaching changes for cross-border online trade with consumers is being driven forward at EU level.

As of 01.07.2021, in B2C distance selling (transactions with end consumers), the previously applicable VAT delivery thresholds in the EU will be abolished and tax amounts will be owed directly in the country of delivery.

The so-called "distance selling regulation" will then apply.

From this point on, cross-border deliveries of goods to non-entrepreneurs will be taxable in the destination member state, and the corresponding amount of VAT will be payable there.

This means, for example, that as of 1.7.21, 20% VAT will be shown on invoices for deliveries to France, and 25% VAT will be shown on invoices for deliveries to Italy. The recipient in Italy therefore no longer benefits from the 19% VAT rate in Germany.

SKU: IC-7300
In stock, shipped in 1 to 2 days.
Supply Scope
  • IC-7300
  • HM-219 Handheld microphone
  • Power cable OPC-1457R with filter
  • Spare Fuses
  • Connector and small parts

The IC-7300 is the first true SDR (Software Defined Radio) transceiver manufactured by one of the three large Japanese amateur radio suppliers. Its main property is that the HF is converted to the digital domain right after the bandfilter. Instead of mixing the signal down to a lower frequency, as it is done with traditional receivers, a fast analog/digital converter is used to immediately digitize the RF signal. In the next step a fast and specialised logic circuit (FPGA) processes the signal (filtering) and sends it on to the audio circuitry. These are the defining components of an SDR: the ADC, the FPGA and of course the software used.

The transmit path is similarly constructed: the modulation is digitised, processed by a DSP and the FPGA in the numerical realm, then transformed to the analog world, filtered and amplified. This results in spectrally very clean signals and excellent values for phase noise. The transmitter of the IC-7300 offers 100 W transmit power and is equipped with an automatic antenna tuner.

The most noticeable item in the IC-7300 transceiver is of course the large and crisp colour LC display. This display is a control at the same time, because it is a touch panel. Just with modern mobile phones you can use your finger to touch items and change settings. The powerful electronics supports a continuously updated (live) waterfall display during reception, with variable speed. The high resolution display with a 4.3" diagonal size (approx. 11cm) not only shows the operating frequency, but also the mode and the S-meter, the clock and of course the waterfall. The spectrum width can be set between 5 and 1000 kHz width. With the touch of a finger you get a magnifying function of the frequency in question, with the next tap you tune very precisely to that frequency. This helps to get a quick overview of the entire band or band segment, whether in a contest or when chasing that rare DX.

The receiver utilizes 15 automatically switched bandfilters in front of the AD converter, resulting in an excellent pre selection. To reduce losses in the bandfilters, high-Q inductivities are used. With the filter the AD chip is only supplied with the signals which are of interest, signals outside the passband are cut off. The results in a much better dynamic range of the AD converter, at 97 dB the RMDR is 15 dB better than in earlier traditional designs.

The IC-7300 transceiver is rounded off with a lot of features for comfort and easy use. The 101 memories can be listed, programmed and organized with the help of the large touch display. The audioo scope function shows the modulation characteristics and the filter settings. All settings and memories can be stored on a removeable SD card for easier management. The connections on the rear of the IC-7300 are the same as the ACC accessory sockets standardised for many years on all Icom desktop transceivers, allowing the continued use of existing options and accessories. A USB socket offer state-of-the-art connection for a computer for CAT control and audio handling. Even the widely used RS-BA1 remote control software can be used with this shortwave transceiver. Included in the shipment is the newly designed HM-219 hand microphone.

Included in shipment IC-7300

  • HM-219 hand microphone

  • Power supply cable

  • Spare fuses

  • Connectors
Technical Data
4 m Band TX capable Yes, as shipped
Supported Bands 10m
60 m Band TX capable Yes, modification required
6 m Band TX capable Yes, as shipped
Weight [kg] 4.20 kgs


We are happy to help!

Whether you have questions about our products, the ordering process or our services, whether you are a complete professional or a beginner - it doesn't matter!  Our experts are there to help you in word and deed - independent of the frequency range and radio application.

Don't hesitate - contact us.