EAntenna

EAntenna Sloper 160m

EAntenna Sloper 160m

EAntenna
€120.00
incl. VAT plus shipping €100.84
incl. VAT plus shipping
SKU: 17902.SL160
In stock, shipped in 1 to 2 days.

The EAntenna EASLP160S is a Lambda-1/4 antenna with a shortening coil to reduce the length of the antenna. The feeding point is located at the top of the mast. Like all Sloper antennas it works like a vertical antenna with a low elevation angle of the main lobe. This gives very good results for DX. The mast gives a directional effect, the mast acts as a reflector. If a wooden mast or another non-conductive mast is used, a cable must be laid from the feed point downwards. The advantage of the sloper antenna is the very easy installation, its flat radiation and the easy adjustment. The bandwidth is approx. 75 kHz (SWR 2:1) with correct installation and average ground conductance, the minimum is at the lower end of the band (CW range). To adjust the antenna for the SSB range it has to be shortened slightly at the lower end, 5cm is usually sufficient.

This antenna does not contain a balun, but you can use a choke (1:1 balun) at the feed point. The antenna wire is 2mm thick and protected against UV radiation to achieve a long life span. The max. permissible transmission power is 2 kW. Weight only 1500g, length of the radiator wire 17.7m, required clamping length with some rope approx. 20m, required mast height for 45° guying approx. 14.2m.


Technical Data
Antenna Type Omni-directional Antenna
Design of antenna Sloper
Mono-/Multiband Monoband
Max. Power [W] 2000 W
Height [m] 12.7 m
Impedance (Ω) 50 Ohm
Length [m] 17.7 m
Supported Bands 160m
Connector PL-Buchse
Weight [kg] 1.50 kgs

STILL HAVE A QUESTION?

We are happy to help!

Whether you have questions about our products, the ordering process or our services, whether you are a complete professional or a beginner - it doesn't matter!  Our experts are there to help you in word and deed - independent of the frequency range and radio application.

Don't hesitate - contact us.